CISCO
500-007
Implementing Cisco TelePresence Video Solution, Part 1
Question: 1
|
You have configured your Cisco TelePresence Codec C90 but
discover unwanted noise during use. What best practice will help avoid this
problem?
A. Connect only one device at a time to an input and
avoid daisy-chaining.
B. Recycle the power on your system after adding each
additional input.
C. If you are not using an input, turn it off.
D. Daisy-chain additional devices using a serial cable to
provide separate power supplies.
Answer:
C
|
Question: 2
|
Refer to the exhibit.
Which two letters
represent input connections on the Cisco TelePresence Codec C90? (Choose
two.)
A. A
B. B
C. C
D. D
Answer:
A,D
|
Question: 3
|
You want to reconfigure the H.323 and SIP settings using
the remote control on the Cisco TelePresence Codec C90. Which menu allows you
to do this?
A. Audio input levels
B. IP settings
C. Advanced configuration
D. Protocol configuration
Answer:
C
|
Question: 4
|
What do you need to do before an endpoint can place or
receive H.323 calls using a URI address?
A. Register the endpoint to the SIP server.
B. Register the endpoints to the gatekeeper.
C. Register the endpoint to the gateway.
D. Register the endpoint to the Cisco TelePresence
MCU.
Answer:
B
|
Question: 5
|
Refer to the exhibit.
You are installing
a high-definition (720p or 1080p) monitor on the Cisco TelePresence Codec C90.
Which of the outputs that are represented by letters in the exhibit should you
use?
A. A or B
B. A or D
C. A or E
D. B or C
E. D or E
Answer:
D
|
Question: 6
|
While on a call, using the remote control, how do you add
an additional participant to a call on your MultiSite-enabled endpoint?
A. Press the Home button to return to the menu, and
select the Add Participant button.
B. Press and hold the End Call key to bring up the
dialing menu.
C. Press and hold the Call key to bring up the dialing
menu.
D. Press the Call key, and choose or dial the number of
the additional participant.
Answer:
D
|
No comments:
Post a Comment